[[missions:ballasthalo:flight3:jobs]]
 
Trace: » master_code » main_downlink » flightlog » telit_gm862_gsm_gprs_module » making_a_serial_cable_for_breakout_boards » start » pegasus7 » i2c » ballasthalo6 » jobs
Table of Contents

Jobs

Hardware

  • 3.3V reg on to slave board
  • make temperature probes
  • improve light sensor setup
  • Level Sensor
    • check circuit
    • add wires, wire up to water bottle, added in LED
    • stripboard circuit
  • Ballast tank
    • added tubing
    • added air vent
  • Make antenna (GP and Stub)
  • Heating circuit
  • Switches
  • Battery connectors
  • Construct payload box

Software

  • ballast control on slave
  • refine master float detection
  • finish passing of data over i2c
  • web interface for additional data
 
missions/ballasthalo/flight3/jobs.txt · Last modified: 2009/11/28 12:19 by jamescoxon
 
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki